Product Center

SY-2008 hydraulic oil filter replace for 07063-01100 175-60-27380 07063-51100 HF6101 HF28977 P557380

Short Description:

QS NO.: SY-2008

CROSS  REFERENCE: 07063-01100    175-60-27380  07063-51100

DONALDSON: P557380

FLEETGUARD: HF6101 HF28977

ENGINE: WA300-1  PC100-3/120-6/130-6/150-6

LARGEST OD: 130(MM)

OVERALL HEIGHT: 292(MM)

INTRNAL DIAMETER: 86


Product Detail

Product Tags

What Does A Hydraulic Filter Do?

Hydraulic fluid is the most important part of every hydraulic system. In hydraulics, no system works without a proper volume of hydraulic fluid. Also, any variation in fluid level, fluid properties, etc.. can damage the entire system we are using. If the hydraulic fluid has this much importance, then what will happen if it gets contaminated?

The risk of hydraulic fluid contamination increases based on the increased usage of the hydraulic system. Leakages, rust, aeration, cavitation, damaged seals, etc… make the hydraulic fluid contaminated. Such contaminated hydraulic fluids created problems are classified into degradation, transient, and catastrophic failures. Degradation is a failure classification that affects the normal working of the hydraulic system by slowing down the operations. Transient is an intermittent failure that occurs at irregular intervals. Finally, catastrophic failure is the complete end of your hydraulic system. The contaminated hydraulic fluid problems can become severe. Then, how do we protect the hydraulic system from contaminants?

Hydraulic fluid filtration is the only solution to eliminate contaminants from fluid in use. Particle filtration using different types of filters will remove the contaminant particles like metals, fibers, silica, elastomers and rust from the hydraulic fluid.

How to clean Hydraulic filter?

Many people think that hydraulic oil filter elements are difficult to clean without cleaning, which will greatly reduce the service life of hydraulic oil filter elements. In fact, there are ways to clean the hydraulic oil filter element. Generally, the original hydraulic oil filter element is made of stainless steel wire mesh. To clean such a hydraulic oil filter element, you need to soak the filter element in kerosene for a period of time. It can be easily removed by blowing it out with wind. It’s stained. However, it should be noted that this method cannot be used if it is not for the original hydraulic oil filter element that is too dirty, and it is better to replace it with a new hydraulic oil filter element.

Product description

QS NO. SY-2008
CROSS REFERENCE 07063-01100 175-60-27380 07063-51100
DONALDSON P557380
FLEETGUARD HF6101 HF28977
ENGINE WA300-1 PC100-3/120-6/130-6/150-6
LARGEST OD 130(MM)
OVERALL HEIGHT 292(MM)
INTRNAL DIAMETER 86

Our Workshop

workshop
workshop

Packing & Delivery

Packing
Packing

Our Exhibition

workshop

Our service

workshop

  • Previous:
  • Next:

  • Write your message here and send it to us